How to replace the hammer with heavy hammer

How to replace the hammer with heavy hammer:

1. Clean up the materials in the heavy hammer first, and then adjust the rotor to a suitable position;

2. Use related equipment to remove the bumps caused by the wear on both sides of the hammer;

3. Put the removed hammer head, pin shaft, fixing sleeve, and bolt in a place where it will not affect the construction;

4. Lift the new alloy hammer head to the crusher port to prevent it from shifting; install a pipe from the grate bed to the rotor, hold the hammer head and push it to a proper position, pay attention to the hammer head down; then install the fixing sleeve And pin shafts and bolts.

5. Observe the gap between the hammer head and the sieve plate of the heavy hammer breaking disc moving rotor body, adjust it appropriately, and test the machine after installation. If inferior hammerheads are used, cumbersome replacement and maintenance will not only not reduce costs, but will affect normal work and operation.

Therefore, I would like to remind users that when purchasing crushing equipment-related machinery and equipment, don't just choose low-quality hammers for cheap, but do a good job of production equipment at one time. The profit is much better than that of cheap.