Several common methods to solve the overheating of wear-resistant hammers in use

With the continuous development of the industry and the improvement of environmental protection in recent years, the user's demand for the quantity and type of wear-resistant hammerhead materials is also increasing. Therefore, the industry will become more prosperous and important.
Pay special attention to details. The wear-resistant hammer will explain how to solve the problem of hammer overheating:
1. If it is the phenomenon of bearing overheating, it can be determined that the bearing is damaged due to insufficient or excessive grease, or dirty and deteriorated grease.
The corresponding solution is to add an appropriate amount of grease, the grease in the bearing should be 50% of the space volume.
Clean the bearings, replace the grease and bearings.
2. If the output decreases, it may be due to a blocked screen gap or uneven paper feeding. The solution is to stop the machine, clear the blockage in the screen gap or adjust the paper feeding structure.
3. If there is a knock on the door inside the machine, it is because no broken objects have entered the machine. The fasteners of the liner were loosened and the hammer hit the liner. The hammer or other parts are damaged; the corresponding solution: stop, clean up the broken
Cavity; check the tightness of the gasket and the gap between the hammer and the screen; replace the damaged parts.
4. If the discharge particle size is too large, the possible cause is that the wear-resistant hammer is too worn or the screen rod is broken. The corresponding solution is to replace the hammer or screen rod.
The above is a brief introduction of Linyi Shenglong Wear-resistant Technology Co., Ltd., which aims to solve the overheating problem of wear-resistant hammers. I hope everyone has to help. If you have other questions about the wear-resistant hammer, you can call our company for consultation.